Install the defence of the diode?

by:Positioning     2021-05-06
Install the defence of the diode? Let the rectifier to tell you! Defence of the diode must first be installed on a particular radiator. Due to the defence of the diode module is insulated type ( The terminal module for insulation between the copper base plate pressure is greater than 3. 1 kv RMS) , so you can install the modules in the same radiator, or device grounding shell. Radiator installation should level off, smooth surface, does not have Nick, knock against and sundry. The radiator surface finish should be less than 10 microns. Defence of the leds to the radiator, between their contact surfaces should be with a very thin layer of thermal conductive silicone. With before, radiator contact surface oxide layer with fine sand paper to remove, and then clean the surface with anhydrous ethanol, made good contact and to reduce the thermal resistance. Defence of the diode when fastening to the radiator surface, using the M5 and M6 screw and spring washer, and as the main 4 nm torque fastening screws and defence of the diode electrode connection should use copper platoon, the contact area and has a smooth level off, make good contact. Defence of the diode work 3 hours later, the screw should be tighten again again. Rectifier, you directly from purchasing, through the network to obtain the most valuable products and services. Your trust and support, is our power to provide you with high quality products and services. — — Every year, every day, we are in progress, only to see your happy smile. If interested in our defence of the diode and the radiator or there is doubt, rectifier welcome your consultation. We serve you wholeheartedly!
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...